From below remove the two black headed philips screws under the fog light location pull the black plastic inner fender liner toward the tire. Watch for the two spring screw clips they may fall off put them back on. now you can see the back of the fog light assembly either the bulb is visiable or the black plastic cover needs to be turned to the left then remove the bulb. do not touch the glass of the new bulb. Skin oils will shorten the life of the new bulb.
How can i change the fog light bulb on 2002 nissan altima?
you have to replace the entire light assembly on that model nissan
How can i change the fog light bulb on 2002 nissan altima?
Smash it with a crow bar and use a screwdriver to pry the pieces out.
Tuesday, September 20, 2011
How do I get to my dash light?
I have a 98' Saturn SC2, my fog lights, tail lights and dash lights were all out, so I changed the fuse and they all work but my dash lights. So I was wondering how do I get in there to change the light so that my car will pass the safety inspection?
How do I get to my dash light?
Check for another blown fuse.
How do I get to my dash light?
Check for another blown fuse.
How to change a bulb in a fog light on a Peugeot 306?
Good luck with that
How to change a bulb in a fog light on a Peugeot 306?
Remove blown bulb and replace with good one!
How to change a bulb in a fog light on a Peugeot 306?
This will take at least 5 cops, 15 lawyers or doctors and 25 politicians.
the bulb comes out from behind the foglight so whatever you have to do or take off to get to it.
How to change a bulb in a fog light on a Peugeot 306?
Remove blown bulb and replace with good one!
How to change a bulb in a fog light on a Peugeot 306?
This will take at least 5 cops, 15 lawyers or doctors and 25 politicians.
the bulb comes out from behind the foglight so whatever you have to do or take off to get to it.
I just bought a 1994 chrysler lhs and I have no high beams and no fog lights.?
I cannot imagine that four bulbs could be out in this thing and nobody bothered to change them so I figure it may be something deeper, also the high beam indicator on the switch does not come on when I pull it so I wonder if the switch would cause it or if it would be something else. I checked the fuse and yes that is ok.
I just bought a 1994 chrysler lhs and I have no high beams and no fog lights.?
you may have a bad multi-function switch. the one you use to activate your high beams.
I just bought a 1994 chrysler lhs and I have no high beams and no fog lights.?
multi function swith-almost bet on it
I must aggree with the others. Bad multi function switch. When u go to turn ur hig beams on, ur driving lights or fog light should cancel out. If this switch is bad then it may cause both systems to not work. The multi function switch is the turn signal handle on the left side of the steering wheel. Be careful messing with it yourself because if you have to remove the steering wheel you may set off the air bag. It aint pretty when one goes off in your face, not to mention the damage and expense it costs. have a pro do it
I just bought a 1994 chrysler lhs and I have no high beams and no fog lights.?
you may have a bad multi-function switch. the one you use to activate your high beams.
I just bought a 1994 chrysler lhs and I have no high beams and no fog lights.?
multi function swith-almost bet on it
I must aggree with the others. Bad multi function switch. When u go to turn ur hig beams on, ur driving lights or fog light should cancel out. If this switch is bad then it may cause both systems to not work. The multi function switch is the turn signal handle on the left side of the steering wheel. Be careful messing with it yourself because if you have to remove the steering wheel you may set off the air bag. It aint pretty when one goes off in your face, not to mention the damage and expense it costs. have a pro do it
Which is the best super yellow or white bulb for the 08 GS350 fog light to match the headlight white color?
I was wondering if anyone can help me on this? Which is the best fog light bulb replacement to match the headlight color (white)? or is there a super bright yellow that's brighter than the stock (faded yellow)? Can i just change the bulb or do i have to do a conversion to a HID?
Which is the best super yellow or white bulb for the 08 GS350 fog light to match the headlight white color?
White bulb...small myspace tv card4
Which is the best super yellow or white bulb for the 08 GS350 fog light to match the headlight white color?
White bulb...
1996 Grand Prix flasher units, gauge, head and fog lights, and transmission...?
need to change flasher units for the signals and maybe the hazards...where are they?
also, i think a light in my instrument panel is blown, as the fuel gauge is much dimmer than the others in the dark...how hard is it to get at these bulbs?
...is there a way to decloud my head and fog lamps? i dont want to have to repolish them every 2 months...
finally, the transmission shifts very hard from 1-2, especially under heavy throttle. it pulls sharply to the left on the shift. is this just torque steer, or am i looking at replacing a halfshaft in a few thousand miles?
1996 Grand Prix flasher units, gauge, head and fog lights, and transmission...?
The flasher unit is located under the dash near the steering column. The turn signal flasher is circular . When i comes to the instrument panel being dim. There is multiple light bulbs in the panel. Remove the trim around the panel and then remove the screws holding the panel in. disconnect cannon plugs. Then you see the socket holding the bulbs in. !/4 turn counter clockwise and then remove , install new bulb and reinstall .Comes to the tranny have it power flushed it solves allot of problems. Headlight your local autoparts has what you need
1996 Grand Prix flasher units, gauge, head and fog lights, and transmission...?
the flasher unit is gunna be under the hood and a big black or gray unit.... the bulbs are really easy to get at autozone but a pain to have to put in most likely the whole dash has to come out to pt them in,,, the headlight issues would be better to replace them once they get water soaked or fog up the only way is to put some glue between the two surfaces.... less trouble to buy a set at a junk yard of not looking to pay brandnew prices....the tranny i would have to leave that to someone else that knows more about them... but to say id say that the pulling is deff torque steer and the tranny may need to be rebuilt... gud luck with that pontiac.....
Sylvania / Bulb - Instrument Panel Light
194R $2.99
also, i think a light in my instrument panel is blown, as the fuel gauge is much dimmer than the others in the dark...how hard is it to get at these bulbs?
...is there a way to decloud my head and fog lamps? i dont want to have to repolish them every 2 months...
finally, the transmission shifts very hard from 1-2, especially under heavy throttle. it pulls sharply to the left on the shift. is this just torque steer, or am i looking at replacing a halfshaft in a few thousand miles?
1996 Grand Prix flasher units, gauge, head and fog lights, and transmission...?
The flasher unit is located under the dash near the steering column. The turn signal flasher is circular . When i comes to the instrument panel being dim. There is multiple light bulbs in the panel. Remove the trim around the panel and then remove the screws holding the panel in. disconnect cannon plugs. Then you see the socket holding the bulbs in. !/4 turn counter clockwise and then remove , install new bulb and reinstall .Comes to the tranny have it power flushed it solves allot of problems. Headlight your local autoparts has what you need
1996 Grand Prix flasher units, gauge, head and fog lights, and transmission...?
the flasher unit is gunna be under the hood and a big black or gray unit.... the bulbs are really easy to get at autozone but a pain to have to put in most likely the whole dash has to come out to pt them in,,, the headlight issues would be better to replace them once they get water soaked or fog up the only way is to put some glue between the two surfaces.... less trouble to buy a set at a junk yard of not looking to pay brandnew prices....the tranny i would have to leave that to someone else that knows more about them... but to say id say that the pulling is deff torque steer and the tranny may need to be rebuilt... gud luck with that pontiac.....
Sylvania / Bulb - Instrument Panel Light
194R $2.99
1995 Mazda 929 head lights will not come on but when i pull back on the light switch the bright lights are on
I changed the bulbs and the relay , the relay clicks when i put it on all the other relays in the relay box clicks but my head light and fog light relays dont . WHAT COULD IT BE?
1995 Mazda 929 head lights will not come on but when i pull back on the light switch the bright lights are on
On most (if not all) cars that have the light switch on the turn stalk, if you pull the stalk to change to high beams, it completes the circuit, causing the lights to flash (even when they are off).
If the brights stay on after the stalk is released, but don't come on normally, I would try replacing the switch. It's not a job for the faint-hearted, so think about taking it to your mechanic. You might check to make sure you don't have a loose ground in the switch before you take it in, but more than likely your light/turn signal switch is toast.
1995 Mazda 929 head lights will not come on but when i pull back on the light switch the bright lights are on
There are two bulbs in the headlight globe - a highbeam and a lowbeam. The lowbeam is burned out.
1995 Mazda 929 head lights will not come on but when i pull back on the light switch the bright lights are on
On most (if not all) cars that have the light switch on the turn stalk, if you pull the stalk to change to high beams, it completes the circuit, causing the lights to flash (even when they are off).
If the brights stay on after the stalk is released, but don't come on normally, I would try replacing the switch. It's not a job for the faint-hearted, so think about taking it to your mechanic. You might check to make sure you don't have a loose ground in the switch before you take it in, but more than likely your light/turn signal switch is toast.
1995 Mazda 929 head lights will not come on but when i pull back on the light switch the bright lights are on
There are two bulbs in the headlight globe - a highbeam and a lowbeam. The lowbeam is burned out.
Subscribe to:
Posts
(Atom)